How to Remove Rear Wiper Arm Ford Explorer
If you’re a Ford Explorer owner and need to remove the rear wiper arm for maintenance or replacement, you’ve come to the right place. Removing the rear wiper arm is a relatively straightforward process that can be completed in just a few steps. In this article, we’ll guide you through the process of how to remove the rear wiper arm on a Ford Explorer.
First, gather the necessary tools for the job. You’ll need a screwdriver, a socket set, and possibly a pair of pliers. Make sure to locate the owner’s manual for your specific model of Ford Explorer, as the steps may vary slightly depending on the year and trim level.
Step 1: Park the Vehicle on a Level Surface
Before you begin, ensure that your Ford Explorer is parked on a level surface. This will prevent the vehicle from rolling while you’re working under it. Engage the parking brake and turn off the engine to ensure safety.
Step 2: Locate the Wiper Arm Nut
Next, locate the wiper arm nut on the rear wiper arm. This nut is typically located on the bottom of the wiper arm, close to the windshield. It may be covered by a plastic cap or cover, which you’ll need to remove first.
Step 3: Remove the Wiper Arm Nut
Using a socket set, loosen the wiper arm nut by turning it counterclockwise. If the nut is tight, you may need to apply some force. Once the nut is loose, you can remove it with your fingers or pliers.
Step 4: Disconnect the Wiper Arm from the Motor
With the nut removed, you should now be able to disconnect the wiper arm from the motor. This is usually done by pulling the wiper arm away from the motor while simultaneously pressing a release button or lever. Refer to your owner’s manual for the exact procedure for your specific model.
Step 5: Remove the Wiper Arm
Once the wiper arm is disconnected from the motor, you can now remove it from the vehicle. Gently pull the wiper arm away from the windshield and set it aside.
Step 6: Install the New Wiper Arm (if applicable)
If you’re replacing the rear wiper arm, now is the time to install the new one. Follow the reverse steps of the removal process to install the new wiper arm. Make sure to securely attach the wiper arm to the motor and tighten the nut.
Step 7: Test the New Wiper Arm
After installing the new wiper arm, test it to ensure it’s functioning properly. Turn on the engine and operate the wiper system to verify that the new wiper arm moves smoothly and effectively clears the windshield.
By following these steps, you should now have successfully removed the rear wiper arm on your Ford Explorer. Whether you were performing maintenance or replacing a faulty wiper arm, this process will help you get back on the road with a clear view. Always remember to consult your owner’s manual for specific instructions related to your vehicle model.
