How-To Guides‌

Step-by-Step Guide to Engage 4WD on a 2016 Ford Explorer

How to Put 2016 Ford Explorer in 4 Wheel Drive

Whether you’re tackling rugged terrain or just want to ensure your 2016 Ford Explorer is ready for any weather condition, knowing how to put it in 4 wheel drive is essential. This article will guide you through the steps to activate the 4WD system in your Ford Explorer, ensuring you’re prepared for whatever challenges may come your way.

Before you begin, it’s important to note that the process may vary slightly depending on the specific model of your 2016 Ford Explorer. However, the general steps outlined below should apply to most models.

1. Park on a Level Surface

Before engaging the 4WD system, make sure your vehicle is parked on a level surface. This will prevent any unnecessary strain on the drivetrain and ensure smooth operation.

2. Turn the Ignition to the “On” Position

With the vehicle parked and the parking brake engaged, turn the ignition to the “On” position. This will allow you to access the necessary controls for engaging 4WD.

3. Locate the 4WD Switch

In your 2016 Ford Explorer, the 4WD switch is typically located on the center console. It may be labeled as “4WD” or “4WD Auto.” Look for a switch with a symbol that resembles four wheels.

4. Engage 4WD Low

To engage 4WD Low, press the switch down until you hear a click. This will lock the front and rear axles together, providing increased traction and control in low-speed, off-road conditions.

5. Engage 4WD High

For higher-speed driving on rugged terrain or snowy conditions, switch to 4WD High. To do this, press the switch up until you hear another click. This will allow the vehicle to maintain a higher speed while still providing increased traction.

6. Test the 4WD System

After engaging the 4WD system, take your Ford Explorer for a short drive to ensure that the system is functioning correctly. Pay attention to the vehicle’s performance and make sure there are no unusual noises or vibrations.

7. Disengage 4WD When Not Needed

Once you’ve reached your destination or are driving on roads with good traction, it’s important to disengage the 4WD system. This will help prevent unnecessary wear and tear on your vehicle’s drivetrain. To do this, simply press the 4WD switch back down to the “Off” position.

By following these steps, you’ll be able to confidently engage the 4WD system in your 2016 Ford Explorer. Whether you’re driving through muddy trails or snowy roads, having the knowledge to put your vehicle in 4WD will help ensure a safe and enjoyable drive.

Related Articles

Back to top button