Step-by-Step Guide to Resetting the Tire Pressure Light on a 2020 Ford Explorer

How to Reset Tire Pressure Light Ford Explorer 2020

Are you experiencing the tire pressure light on your 2020 Ford Explorer illuminating? Don’t worry; you’re not alone. This common issue can be caused by various factors, such as a low tire pressure or a faulty sensor. In this article, we will guide you through the steps on how to reset the tire pressure light on your 2020 Ford Explorer.

Firstly, it’s essential to note that the process may vary slightly depending on the specific model of your Ford Explorer. However, the general steps should be similar for most 2020 models. Before proceeding, ensure that your vehicle is parked on a flat, level surface and the engine is turned off.

1. Locate the Tire Pressure Monitor System (TPMS) reset button: The TPMS reset button is typically located on the driver’s door jamb or near the driver’s side dashboard. It may be labeled as “TPMS Reset” or have a small tire icon.

2. Turn the ignition to the “On” position: Before pressing the TPMS reset button, make sure the ignition is turned to the “On” position, but the engine is not running.

3. Press and hold the TPMS reset button: Once the ignition is on, press and hold the TPMS reset button for approximately 10 seconds. You will notice the tire pressure warning light start to flash, indicating that the system is resetting.

4. Release the TPMS reset button: After 10 seconds, release the TPMS reset button. The tire pressure warning light should turn off, indicating that the system has been reset successfully.

5. Verify the reset: To ensure that the tire pressure light has been reset, turn the ignition off and then back on. The tire pressure warning light should not illuminate.

If the tire pressure light comes back on after the reset, it could be an indication of a more serious issue, such as a faulty sensor or low tire pressure. In this case, it’s advisable to have your vehicle checked by a professional mechanic.

Remember that maintaining proper tire pressure is crucial for your safety and the performance of your 2020 Ford Explorer. Regularly check your tire pressure using a reliable tire pressure gauge and follow the recommended pressure levels specified in your vehicle’s owner’s manual.

By following these simple steps, you should be able to reset the tire pressure light on your 2020 Ford Explorer without any hassle. However, if you continue to experience issues, it’s best to consult a professional for further assistance.